- Subscribe to RSS Feed
- Mark Thread as New
- Mark Thread as Read
- Float this Thread for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Today I was inputting some new products for one of our vendors. For this vendor I create all the SKUs we use to barcode the product, they are not provided. So for example when I inputed AU040 it accepted it and I then went to print barcodes where I realized I had already used that SKU (I wish there was a columb when viewing all products in a category that listed the SKUs). Normally when I would enter a duplicate SKU square would notify me and not allow me to save the product until the SKU was changed, however after doing a test with using other duplicate SKUs it still did not notify me. Is this a new change? Has anyone else noticed this?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report
Hello @AdornCapeCode, this shouldn't be the case unless you're using Square for Retail.
If you are just using Point of Sale I recommend reaching out to our Support Team. They will be able to take a closer look at your items and SKU's. 😀
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report